Security door performance standard

Executive standard

"General technical conditions for anti-theft security doors" GB/T 17565-2007 [1]

Technical performance

Exterior

Inferior security door

(1) The surface of the door frame and door leaf components should be smooth and clean, without obvious dents and mechanical damage.

(2) The sign on the nameplate should be correct, firm and clear.

(3) The anti-theft security door should be marked with a permanent anti-theft security level.

(4) The anti-theft security level mark consists of its Chinese code and a plane circle. The Chinese code should be located in a plane circle with a diameter of Φ25mm.

(5) Permanently fix it on the upper corner of the inner hinge edge in the form of Song gravure, at a height of 1600mm±100mm from the ground.

Plate and material

(1) The material of the plate can be steel, stainless steel, steel/wood, copper or other composite materials.

(2) Thickness of steel sheet

a) The door frame should be 2.00mm, 1.80mm and 1.50mm according to the B, C and D grades of anti-theft safety.

b) The thickness of the outer panel and inner panel of the door leaf is expressed in the form of "outer panel/inner panel". According to the B, C and D grades of anti-theft safety, 1.00mm/1.00mm, 0.80mm/0.80mm, 0.80mm/0.60 should be selected respectively. mm.

c) The thickness of the plate of the Class A anti-theft security door shall be selected according to the product design under the condition that it meets its anti-destructive performance. If the steel sheet is selected, its thickness should not be lower than the thickness and allowable deviation requirements of the door frame and door leaf of the class B anti-theft security level.

Failed

Unqualified anti-theft doors, as the name suggests, do not meet the national standards for anti-theft doors. There are many kinds of unqualified security doors in the market, as long as consumers keep a calm mind. Don't be tempted by low-priced doors. Basically, you will not buy substandard security doors.